NodeID | Name | Description | Manufacturer | ID | Type | Last Seen | Enable Polling | Status |
---|
Update Delete | Refresh |
: |
Code | Value | Action |
---|
Refresh |
Nodes |
NodeID | Name | Sketch Name | Version | Childs | Last Seen |
---|
Update Delete | Refresh |
Childs |
ChildID | Type | Name | Values | Ack | Ack Timeout | Last Seen |
---|
Update Delete | Refresh |
: | |
(ms) |
Settings |
(Seconds) | |
() | |
Apply Settings |
Nodes |
ID | Name | IP Address | Timeout |
---|
Update Delete | Clear |
(Seconds) | |
Add |
Settings |
(Seconds) | |
() | |
Apply Settings | |
Auto Searching on: |
Nodes |
ID | Name | IP Address | Type | Uptime | Hardware | Firmware |
---|
Delete | Update devices firmware | Clear |
Add |
Settings |
(Seconds) | |
() | |
Apply Settings |
Idx | Name | Enabled | Type | Address | Port | Data Timeout |
---|
Update Delete |
: | |
|
() | |
() |
|
|
|
|
()
Make sure the correct pin status is read by introducing a bounce delay. |
|
()
Maximum of one interrupt per pin allowed in this period (prevents interrupt storms). |
|
Auto configure devices: | |
CRC message validation: |
Using CRC message validation prevents incorrect data from entering the Domoticz database. |
Seconds
This limits the amount of meter updates. |
Poll inputs: | |
Poll relays: | |
Poll interval: | Seconds |
Auto Discovery: | |
Alarm Inputs: | |
eHousePRO Enable: | |
Change only to select another Toon when having multiple agreements |
(Seconds) | |
Leave the username empty and press the LINK button on the Philips Hue bridge. Then press the 'Register on Bridge' button. |
|
Register on Bridge |
Select the Topic('s) Domoticz will use to publish outgoing messages. Flat - publish outgoing messagen on topic domoticz/out. Hierarchical - publish outgoing messagen on topic domoticz/out/${floorplan name}/${plan name}. Combined - Use both Flat and Hierarchical topic schemes. None - disable outgoing messages. Note that Hierarchical only reports sensor updates for sensors that are placed on a floorplan/plan. |
|
Add extra parameteres to rtl_433 command line. You may for instance :
|
Select the Topic(s) where Domoticz publish/receive messages. MyMQTT (default) - domoticz/in/MyMQTT, domoticz/out/MyMQTT Gateway Node Name - domoticz/in/GatewayNodeName, domoticz/out/GatewayNodeName (GatewayNodeName is specified in the Name field (above)) |
|
(Seconds) This sets the interval between status requests. If you set this to less than 60 seconds you may be in violation of Honeywell's usage terms and have your account suspended! |
|
Synchronize installation: |
When enabled this will automatically register and keep your zone names in sync with the Evohome controller. |
Show schedule: |
When enabled this will show the next scheduled switch point when in Auto (FollowSchedule) mode. |
Show location: |
(implies synchronize installation) |
,
,
(keep at [0,0,0] if you only have one Evohome installation) |
|